Mark D
 ·   · 104 posts
  •  · 80 friends
  •  · 79 followers

Humidity control

So made these to try and retain a bit more humidity around the plants. Very dry right now thought they could use something like this to help. They will be fine but anything will help.

Designed in Fusion360 and printed on ender 5 in vase mode.

Guess they could be closed with plastic wrap. Seems to help. Revisit in a few days

0 0 0 0 0 0
  • Set badges
  • View
    258
Comments (5)

    • Have you considered buying a humidifier? A pot of water in the corner helps too. I do admire your ingenuity though.  

      0 0 0 0 0 0

      • Haha! That would be too easy, this was just an experiment. really if it worked I might use them outside to keep squirrels at bay. and the occasional extra humidity here and there where needed.

        1 0 0 0 0 0

        • I thought that material would degrade in sunlight, if it doesnt in the tent it shouldn't outside though. I have been thinking about buying a 3-d printer, I have been building 3-D Cad models for about 30 years so I got that part going for me. 

          0 1 0 0 0 0

          • PETG same stuff you see for decades at the side of the road. recycles nicely.

            0 0 0 0 0 0

          • A little update, this seems to be a happy plant. 

            Apparently it raised enough for the plant to notice.  Seems happier than the one that is not in the dome. 

            Of course they both well fed and thats good too

            0 0 0 0 0 0
            Not logged in users can't 'Comments Post'.
            Info
            Category:
            Seedling
            Created:
            Updated: